You can support the Dinosaur Toy Forum by making dino-purchases through these links to Ebay and Amazon. Disclaimer: these and other links to Ebay.com and Amazon.com on the Dinosaur Toy Forum are often affiliate links, so when you make purchases through them we may make a commission.

3D Printed T.Rex, high resolution

Started by DinoMakers, November 06, 2014, 06:41:43 PM

Previous topic - Next topic

DinoMakers

Hello everyone,

We made this awesome 3D printed T.Rex, and would appreciate some feedback, whatever comes to your mind.

See the pictures below:







For more information, you can find us here:
https://www.kickstarter.com/projects/1148168729/trex-an-affordable-high-quality-dinosaur-fossil

Thank you!


DinoLord

Decent start. With some more attention to anatomy this could be a great model!

DinoMakers

Like what? We did this modelling and design based on pictures, but clearly looks off, or anatomically incorrect?

Thanks!

DinoLord

All the bones are there, but their proportional sizes to each other are not correct. The torso is too long and the head should be larger. Also the arms are too long, and the wrists are facing the wrong way. The palms should be facing inwards, not downwards.

Also the tail would not be raised up like a scorpion. Most dinosaurs had relatively stiff and straight tails.

Check out this skeletal drawing of T. rex 'Stan' to see what I mean:


DinoMakers

You are right! This is good advice and I will take it into consideration for the next model

Thanks

Roselaar

Anatomical inaccuracy notwithstanding, it's a good model, especially if you're new to this. The pose is a bit odd though, I must say.

Alexxitator

I am by no means a specialist on the subject but here are my pennies, since you asked for it  ^-^
I think both the head and the legs have the right bulk. Comparative sizes are not correct though. The head is a bit small.
The ribs are a bit like toothpicks. The arms aswell, and too long as I saw mentioned earlier.
The spinal column and tail could do with a bit more bulk, the tail indeed should be straighter vertically.
Ileum bone seems a bit high, torso too long.
I really like the base.

Having said all that; I really wish I was able to make any sort of 3D figure -at all!-
To kill an error is as good a service as, and sometimes even better than, the establishing of a new truth or fact.
-Charles Darwin-

Amazon ad:

DinoLord

Quote from: DinoMakers on November 06, 2014, 08:11:00 PM
You are right! This is good advice and I will take it into consideration for the next model

Thanks
You're welcome.  ;)

There aren't many dinosaur skeleton models available in the market (except for some very high end resin sculptures ranging in the hundreds of dollars) so I think this could be a good niche for you guys to explore. As long as you take anatomy into account (skeletal drawings and different angled photos of museum mounts and fossil specimens are helpful for this) I think you have the potential to create some strong models. If when the time comes you want to post preliminary or progress photos of the next model, I (and probably many other members) would be happy to give feedback.

RockyMountainRex

An addition to contemplate, that are absent on a few models of this type, would be some gastralium (or "belly ribs") maybe?   :)
Rawr!

You can support the Dinosaur Toy Forum by making dino-purchases through these links to Ebay and Amazon. Disclaimer: these and other links to Ebay.com and Amazon.com on the Dinosaur Toy Forum are often affiliate links, so when you make purchases through them we may make a commission.