Help with carnegie figure

[delta653]

Hi guys, i've recently bought the carnegie giganotosaurus figure and i gotta say, im loving it. However, when it arrived, one of it's legs came warped. As a result, the figure is unable to stand. Can someone provide a solution to fix this problem. Your help will be appreciated. Thx

[amargasaurus cazaui]

Seen several people suggest the hot water approach. Get some water boiling, place the leg in water till it gets bendy, pose it how you want, then run under cold water to set in place. Then place it in the freezer for a few hours to set it good and hard.
    Failing that you could just like the figure down and announce its a new offering, a dead giganotosaurus.

[alexeratops]

Get some boiling water, pour it into a tall glass cup, put his foot\leg in there for 20 seconds, take it out. By then it will be really pliable, then you can move it to the pose you want, then put it into the freezer for half an hour. Poof! You have got yourself a standing Gigonotosaurus! You're welcome .Aw, come on! Someone posted while I was posting!

[SBell]

A good blow dryer can work just as well, without the risk of washing any paint away.

But the most important part really is the coldwater dip after.

[tyrantqueen]

Sometimes I wish the admin would make a sticky of a thread like this. It pops up a LOT, and the same answer gets repeated.

[delta653]

I've tried the method u guys suggested, and i'm happy to say that it works! Ty for your advice.

P.s, can a mod pls close this thread, as the issue is now fixed.