Glue for Metal to Resin - What Type?

[Torvosaurus]

I'm rebuilding an HLBS liopleurodon that has metal and resin parts. I was never happy with super glue holding resin to metal; it came apart too many times. It's stripped and pins are added, so I wondered if anybody had any recommendations?

Torvo

[PumperKrickel]

An epoxy glue would probably be the best bet. Make sure the metal surface isn't smooth, so the glue has something to grip. Scratching some grooves should suffice.

[Justin_]

I do a lot of small-scale modelling and I'm not a fan of super glue. I use epoxy glue that comes in two separate tubes, rather than the double syringe, so it is easier to just mix the small amount I need. One that sets in 5 to 10 minutes is best as you can just hold the parts in place with your fingers.

[Torvosaurus]

Thank you.

I used a two part epoxy and it worked well.

Torvo